Care and Maintenance 7 7.8.5.3 Draining the fuel filter Open the fuel filter on the water drain (50/2) until pure fuel escapes. Close again the water drain. 1 7.8.5.4 Replacing the fuel filter 2 Clean the outside of the fuel filter (50/1). Attention Collect the fuel in a suitable container and dispose of according to regulations. Open the water drain (50/2) on the filter bottom to drain fuel from the filter. Unscrew the filter housing (51/4) using commercially available tools and remove the filter housing along with the filter element from the filter flange. Fig.
50 Draining and replacing the fuel filter Push down the filter element against the springs on the filter element (51/1) and turn to the left to remove it from the filter housing (51/4). Dispose of the filter element according to regulations! Push down the new filter element (51/1) against the springs and turn to the right to snap it into place in the filter housing (51/4). Install the new seal (51/3) on the filter housing. Slightly wet the surface of the seal with clean fuel. Examine the thread (51/2) on the inside of the filter element for possible damage. Place the filter onto the filter flange and tighten by hand until the filter touches the flange.
Tighten the filter manually by another quarter turn. Do not use any tools for this purpose. Fig. 51 Replacing the fuel filter Close the drain cock (52/2) on the fuel filter (52/1) and remove the container. 2 Machine damage 1 due to air in the filter. Before starting the engine, operate the fuel pump one minute to remove air from the filter. Start the engine and check for leaks. Fig. 52 Replacing the fuel filter 82/112 TL160 Operating Manual 12.9.08 Version 1.0 1 2 3 4