Terex TL160 — 7.8.15 Wheels

Care and Maintenance 7 7.8.14.3 Wheel hub Checking the axle oil level Remove the inspection plug (77/1). Check if the oil is up to the edge of the inspection hole. Top up oil if required. Carefully close the inspection plug. Changing axle oil Attention The wheel hub has a combined inspection, filling and drain plug! Turn the wheel until the screw plug (77/1) on the hub is at the bottom (drain position). Fig. 77 Checking and replacing the axle oil Open the screw plug and catch the escaping oil. Flush out if necessary. Turn the wheel to the filling and inspection position; the inspection mark must be horizontal (77/1). Fill in oil up to the lower edge of the inspection hole.

Carefully close the screw plug. 7.8.15 Wheels 7.8.15.1 Checking the tire pressure Check the air pressure in accordance with the pressure chart given in О 3.8, 29. 7.8.15.2 Checking the tightness of wheel nuts During the first 50 operating hours, check the tightness of the wheel nuts (M 22 x 1.5) daily and subsequently every week, and tighten to the correct torque if necessary. Attention Note that the tightening torque of 610 Nm applies to the wheel nuts M 22 x 1.5. When fitting a wheel, tighten the nuts to the correct torque crosswise in several stages. 99/112 TL160 Operating Manual 12.9.08 Version 1.0