MAINTENANCE PROCEDURE 4.8.6.b CHECKING THE GEARING CHAIN TEN- SION q Stop the machine on firm and level ground, raise the front and rear wheels until they are not in contact with the ground any longer and engage all the safety locks before stopping the engine. q Secure the machine in this position by applying bearing blocks under the front part of the frame. RWA31870 FRONT CHAINS After raising the front part of the machine and securing it in this position with safety blocks, mark a point on the outer perimeter of the front rim and, moving the wheel, make sure that the point moves of a distance included between 2 and 6 mm. This range determines the correct tension of the chain.
Repeat this operation also for the opposite wheel. REAR CHAINS After raising the rear part of the machine and securing it in this position with safety blocks, mark a point on the outer perimeter of the rear rim and, moving the wheel, make sure that the point moves of a distance included between 2 and 6 mm. This range determines the correct tension of the chain. Repeat this operation also for the opposite wheel. IMPORTANT q Check the tension on the front and rear wheels and if the slack exceeds 6 mm, contact your Komatsu Dealer. RWA32530 185 WARNING