Komatsu — 4.8.6.b CHECKING THE GEARING CHAIN TEN SION

MAINTENANCE PROCEDURE ADJUSTING THE CHAINS q The adjustment must be carried out with the machine parked on a firm, level and not slippery surface. q Before carrying out the adjustment, take all the neces- sary safety precautions. q When adjusting the hub-holding plate, do not loosen the fastening nuts by giving them more than 2 turns, in or- der to prevent any oil leakage. If the wheel slack exceeds 6 mm, carry out the following ope- rations: 1 - Remove the wheel nuts using a 24 mm hexagon spanner. 2 - Position the adjusting screw (3) included in the supply on the appropriate hole and make it rest against the hub-hol- ding plate (1). Use a 17 mm hexagon spanner.

3 - Loosen the nuts (2) of the hub-holding plate (1), giving them max. 2 turns. Use a 22 mm hexagon spanner. 4 - Adjust the screw (3), moving the hub-holding plate 1 or 2 mm forwards. 5 - Fasten at least 3 diametrically opposite nuts (2) of the hub-holding plate. 6 - Install the wheel and check the wheel slack. If the wheel slack value is not included within the prescribed value range, repeat the operations described above. If, on the contrary, the wheel slack value is included within this range, proceed as follows: 1 - Remove the wheel again. 2 - Tighten all the nuts (2) of the hub-holding plate (1) by ap- plying the prescribed driving torque (see "4.4.1 STAN- DARD DRIVING TORQUES").

3 - Remove the adjusting screw (3). 4 - Put back the wheel definitively, tightening the nuts with the prescribed torque (see "4.4.2 SPECIFIC DRIVING TOR- QUES"). Repeat this procedure also for the other wheels. IMPORTANT q It is important to remember that each side of the final transmission (right and left) is constituted by two chains (front and rear) that transmit motion to the correspond- ing wheels. Each chain can be adjusted independently of the others. 186 WARNING CAUTION