MAINTENANCE PROCEDURE 4.8.6.c CLEANING THE OUTSIDE OF THE RADIATORS q If compressed air, steam or water are directed against a person, they may cause injuries. Always wear an eye shield and safety shoes. The outside of the radiators must be cleaned with a jet of com- pressed air and, if necessary, with a low-pressure water or ste- am washing cycle; the specific products available on the market can certainly be used, provided that the instructions gi- ven on the package are followed and that the washed parts are carefully dried at the end of the operations.
IMPORTANT q Do not use products containing oily substances, even if in slight quantities, since these facilitate the adhesion of dust, which affects the heat exchange adversely. q Clean the outside of the radiators whenever the radiator and the heat exchanger are dirtied, even if accidentally, with oil, diesel oil, greasy or oily substances. q If the machine is used in dusty places, clean the radiator and the heat exchanger more frequently, in order to avoid the clogging of the fins. 4.8.6.d CHECKING THE WHEEL NUT DRIVING TORQUE q On new machines, check the wheel nut driving torque after the first 50 hours of operation and successively every 250 hours.
This check serves to restore the correct driving torque of the wheels on the hubs. The torque must be checked with a dynamometric spanner (1) calibrated with the values indicated in paragraph "4.4.2 SPE- CIFIC DRIVING TORQUES". Use a 24 mm spanner. IMPORTANT q Do not increase the specified driving torque and keep it within the prescribed values. q When checking the driving torque, do not lubricate the thread. 187 WARNING CAUTION