MAINTENANCE PROCEDURE 4.8.6.f LUBRICATING THE JOINTS IMPORTANT q Clean the grease nipples before applying the greasing pump. q After lubrication, remove any excess grease. q If the machine is used in difficult conditions, perform these maintenance operations more frequently. These maintenance operations must be carried out with the arm completely lowered and the bucket resting on the ground. For the lubrication, use a syringe and the recommended grease. (See "4.3 FUEL, COOLANT AND LUBRICANTS").
NOTE q As a general rule, consider that each cylinder is provided with two grease nipples positioned on the couplings and that each pin serving as fulcrum for a movement is provided with at least one grease nipple. EQUIPMENT LUBRICATION POINTS RWA31840 3 4 5 6 7 2 1 189 1 - Bucket coupling pin (2 points) 2 - Tool-holder plate fulcrum pin (2 points) 3 - Bucket cylinder head pin (2 points) 4 - Bucket cylinder base pin (2 points) 5 - Lifting cylinder head pin (2 points) 6 - Arm fulcrum pin (2 points) 7 - Lifting cylinder base pin (2 points)