Cummins — 4021531

QSB4.5 and QSB6.7 Cooling Fan Belt Tensioner Section 6 - Maintenance Procedures at 1000 Hours or 1 Year Page 6-1 Maintenance Procedures - Overview General Information All maintenance checks and inspections listed in previous maintenance intervals must also be performed at this time, in addition to those listed under this maintenance interval. Cooling Fan Belt Tensioner Maintenance Check With the engine stopped, check the tensioner arm, pulley, and stops for cracks. If any cracks are found, the tensioner must be replaced. With the belt installed, verify that neither tensioner arm stop is in contact with the spring case stop. If either of the stops is touching:

Verify the correct belt part number is installed. If the correct belt is installed, replace the belt. Refer to Procedure 008-002 in Section A. After replacing the belt, if the tensioner arm stops are still in contact with the spring case stop, replace the tensioner. With the belt removed, verify that the tensioner arm stop is in contact with the spring case stop. If these two are not touching, the tensioner must be replaced. After replacing the belt, if the tensioner arm stop is still in contact with the spring case stop, the tensioner MUST be replaced.