Fan Hub, Belt Driven QSB4.5 and QSB6.7 Page 6-2 Section 6 - Maintenance Procedures at 1000 Hours or 1 Year Check the location of the drive belt on the belt tensioner pulley. The belt should be centered on, or close to the middle of, the pulley. Misaligned belts, either too far forward or backward, can cause belt wear, belt roll-offs, or increase uneven tensioner bushing wear. Remove the drive belt. Refer to Procedure 008-002 in Section A. With the belt removed, verify that the tensioner arm stop is in contact with the spring case stop. If they are not touching, the tensioner must be replaced. Fan Hub, Belt Driven Maintenance Check Remove the drive belt. NOTE:
The fan hub must rotate without any wobble or excessive end play. Fan Hub End Play mm in 0.15 MAX 0.006