QSB4.5 and QSB6.7 Cooling System Section 7 - Maintenance Procedures at 2000 Hours or 2 Years Page 7-3 Do not add cold coolant to a hot engine. Engine castings can be damaged. Allow the engine to cool below 50°C [120°F] before adding coolant. CAUTION On applications that use a coolant recovery system, check to make sure the coolant is at the appropriate level on the coolant recovery tank, for the engine temperature. Many coolant recovery/expansion tanks, also called “top tanks”, have sight glasses (1) or are made of a clear material (not shown) to aid in checking the coolant level (2) without removing the radiator cap.
Fill the cooling system with coolant to the bottom of the fill neck in the radiator fill or recovery/expansion tank. NOTE: Some radiators have two fill necks, both of which must be filled when the cooling system is drained. Drain Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [122°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Remove the radiator/expansion tank cap. Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations.
WARNING Drain the cooling system by opening the drain valve on the radiator and removing the plug in the bottom of the water inlet. A drain pan with a capacity of 19 liters [5 gal.] will be adequate in most applications.