Cummins — 4021531

Overhead Set QSB4.5 and QSB6.7 Page 8-4 Section 8 - Maintenance Procedures at 5000 Hours or 4 Years Align the vibration damper/crankshaft speed indicator ring so the TDC indicator is at the 12 o'clock position. If both number 1 cylinder rocker levers are loose, move to the following steps. If both number 1 cylinder rocker levers are not loose, rotate the crankshaft 360 degrees. NOTE: If no TDC mark is present on either the vibration damper or the crankshaft speed indicator ring, align the large gap in the crankshaft speed indicator ring to the 5 o'clock position (2). The dowel pin will be visible in the 9 o'clock position (1). Check that both number 1 cylinder rocker levers are loose.

If they are not loose, rotate the crankshaft 360 degrees and check again. With the engine in this position, lash can be checked on the following rocker arms: (E = exhaust, I = Intake) Four-cylinder 1I, 1E, 2l, and 3E Six-cylinder 1I, 1E, 2I, 3E, 4I, and 5E. Lash Check Limits mm in Intake 0.152 MIN 0.006 0.381 MAX 0.015 Exhaust 0.381 MIN 0.015 0.762 MAX 0.030 NOTE: Checking the overhead setting is usually performed as part of a troubleshooting procedure, and resetting is not required during checks, as long as the lash measurements are within the above ranges.