Cummins — 4021531

QSB4.5 and QSB6.7 Overhead Set Section 8 - Maintenance Procedures at 5000 Hours or 4 Years Page 8-5 NOTE: The clearance is correct when some resistance is “felt” when the feeler gauge is slipped between the crosshead and the rocker lever socket. Measure lash by inserting a feeler gauge between the crosshead and the rocker lever socket. If the lash measurement is out of specification, loosen the locknut, and adjust the lash to nominal specifications. Tighten the locknut and measure. Torque Value: 24 N•m [ 212 in-lb ] Use the barring tool, Part Number 3824591, to rotate the crankshaft 360 degrees.

Following the same steps and specifications as previously stated, measure lash for the following rockers: (E = Exhaust, I = Intake). Four-cylinder 2E, 3I, 4E, and 4I: Six-cylinder 2E, 3I, 4E, 5I, 6I, and 6E. Reset if out of specification. Install Stud Mounted Rocker Lever Cover. Install the rocker lever cover over the mounting capscrews. Install the isolators and mounting nuts. Tighten the mounting nuts. Torque Value: 24 N•m [ 212 in-lb ] Capscrew Mounted Rocker Lever Cover. Install the rocker lever cover. Install the mounting capscrews and isolators. Tighten the mounting capscrews. Torque Value: 24 N•m [ 212 in-lb ] Lash Specifications mm in Intake 0.254 0.010 Exhaust 0.508 0.020