Cummins — 4021531

Alternator QSB4.5 and QSB6.7 Page A-4 Section A - Adjustment, Repair, and Replacement Initial Check Check the drive belt and alternator pulley to be sure the alternator is rotating properly. If any problems exist, check the following: If the drive belt is slipping on the alternator pulley. Refer to Procedure 008-002 in Section A. Use the following procedure to inspect the belt tensioner. Refer to Procedure 008-087 in Section A . Remove the drive belt. Refer to Procedure 008-002 in Section A. Check if the alternator pulley is loose on the shaft. If loose, remove the pulley and inspect for damage. Refer to the alternator manufacturer's and/or OEM service manual.

If the alternator will not rotate or does not rotate freely, the alternator must be replaced. See the Remove and Install sections of this procedure. WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Check the battery and all wiring connections. Inspect the wiring for damage. Check all connections for tightness and cleanliness. This includes the slip connectors at the alternator and engine compartment bulkhead, and the connections at the battery. Test NOTE:

Any multimeter reading of zero voltage indicates an open circuit. Check for open circuits. Turn the keyswitch to the ON position. Connect a multimeter, Part Number 3164488 or 3164489, to the following locations: Delco™ Alternators Alternator “BAT” terminal to ground Alternator blade terminal “number 1” to ground Alternator blade terminal “number 2” to ground. Locate and repair the open circuit.