Cummins — 4021531

QSB4.5 and QSB6.7 Coolant Thermostat Section A - Adjustment, Repair, and Replacement Page A-9 Finishing Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING Acid is extremely dangerous and can damage the machinery and can also cause serious burns. Always provide a tank of strong soda water as a neutralizing agent when servicing the batteries. Wear goggles and protective clothing to reduce the possibility of serious personal injury. WARNING Connect all wires to the alternator.

Install the drive belt. Refer to Procedure 008-002 in Section A. Connect the batteries. Refer to the OEM service manual. Operate engine to check for proper operation. Charge-Air Cooler Maintenance Check Inspect the charge-air cooler (CAC) for dirt and debris blocking the fins. Check for cracks, holes, or other damage. If damage is found, refer to the vehicle, vessel, or equipment manufacturer. Coolant Thermostat General Information The thermostat controls the engine coolant temperature. When the coolant temperature is below the operating range, engine coolant is bypassed back to the inlet of the water pump.

When the engine coolant temperature reaches the operating range, the thermostat opens, seals off the bypass, and forces engine coolant to flow to the radiator or the heat exchanger. NOTE: Some applications use an OEM supplied remote mounted thermostat. Refer to the OEM service manual for location. Refer to the OEM service manual for remote mounted thermostat removal and installation instructions. An incorrect or malfunctioning thermostat can cause the engine to run too hot or too cold.