QSB4.5 and QSB6.7 Starting Motor Section A - Adjustment, Repair, and Replacement Page A-19 NOTE: Some applications do not have a cooling fan or the cooling fan is located elsewhere on the application. For engines equipped with an engine driven cooling fan, the fan holds the fan pulley and spacer in place. Install the fan pulley and spacer. If removed, install the cooling fan. Refer to the OEM service manual for instructions. NOTE: Use the tension of the drive belt to hold the cooling fan in place when tightening the mounting capscrews. Do not hold the fan blades to keep the cooling fan from rotating. Do not tighten the mounting capscrews at this time.
Tighten the mounting capscrews after the drive belt is installed. Torque Value: M6 10 N•m [ 89 in-lb ] Torque Value: M10 43 N•m [ 32 ft-lb ] Torque Value: M12 77 N•m [ 57 ft-lb ] Finishing Steps WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Connect the batteries. Refer to the OEM instructions. Start the engine and check for proper operation.
Starting Motor Rotation Check If the starter solenoid is making a sound but the engine is not rotating, turn the keyswitch to the OFF position, and attempt to bar the crankshaft in both directions. Bar the engine with the barring tool, Part Number 3824591. If the crankshaft will bar over, attempt to start the engine. If the starter motor cranks the engine, check the starter motor pinion gear and flywheel ring gear for damage. If damage to the starter motor pinion gear and/or flywheel ring gear is found when replacing the components, make sure to measure the distance from the starting motor mounting flange to the forward face of the front side of the flywheel ring gear.
Follow the measure step of this procedure.