Cummins — 4021531

Fan Spacer and Pulley QSB4.5 and QSB6.7 Page A-18 Section A - Adjustment, Repair, and Replacement Clean and Inspect for Reuse When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. WARNING Clean the fan pulley and spacer with solvent and dry with compressed air. Inspect the fan pulley for cracks near the bolt holes and for damage at the drive belt contact surface. If damage is found on the fan pulley, the fan hub must also be inspected. Refer to Procedure 008-036 in Section 8. Replace the pulley if any damage is found. Install NOTE:

Use the tension of the drive belt to hold the cooling fan in place when tightening the mounting capscrews. Do not hold the fan blades to keep the cooling fan from rotating. If the engine is not equipped with an engine driven cooling fan, install the fan pulley mounting capscrews and fan pulley. Do not tighten the mounting capscrews at this time. Tighten the mounting capscrews after the drive belt is installed. Torque Value: M6 10 N•m [ 89 in-lb ] Torque Value: M10 43 N•m [ 32 ft-lb ] Torque Value: M12 77 N•m [ 57 ft-lb ]