QSB4.5 and QSB6.7 Starting Motor Section A - Adjustment, Repair, and Replacement Page A-21 Preparatory Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING WARNING When using a steam cleaner, wear safety glasses or a face shield, as well as protective clothing. Hot steam can cause serious personal injury. Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING Disconnect the batteries.
Refer to the OEM service manual. Remove Identify each wire with a tag inicating its location on the starting motor. Remove the electrical connections from the starting motor. Remove the three capscrews and the starting motor. NOTE: If equipped with a starting motor spacer, remove the spacer and clean all surfaces between the starting motor, starting motor spacer, and flywheel housing with a wire brush. Clean and Inspect for Reuse For engines that use wet flywheel housings, clean any left over sealant from the starting motor mounting flange on both the flywheel housing and starting motor. Make sure these surfaces are clean of oil and debris.