Starting Motor QSB4.5 and QSB6.7 Page A-22 Section A - Adjustment, Repair, and Replacement Inspect the starter motor pinion gear and/or flywheel ring gear for chipping or uneven wear. NOTE: If the starter motor pinion gear and/or flywheel ring gear teeth are damaged, they must be replaced. Install For engines with wet flywheel housings, apply a 1.5 to 2.0 mm [0.06 to 0.09 in] wide bead of sealant, Part Number 3164067, to the flywheel housing starting motor mounting flange. NOTE: If a starting motor spacer is required, make sure to apply sealant to the side of the spacer that contacts the starting motor. Install the three capscrews, the starting motor, and starting motor spacer, if required.
Torque Value: 43 N•m [ 32 ft-lb ]