Cummins — 4021531

Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-20 Section TS - Troubleshooting Symptoms Engine Difficult to Start or Will Not Start (Exhaust Smoke) Cause Correction STEP 1 Starting procedure is not correct ............. Verify the correct starting procedure. Refer to Section 1. OK Go To Next Step STEP 2 Fuel level is low in the tank ............. Fill the supply tank. Refer to the OEM service manual. OK Go To Next Step STEP 3 Electronic fault codes are active or high counts of Review instructions for reading active fault codes. Contact a Cummins® Authorized Repair Location, if fault codes are active. inactive fault codes .............

OK Go To Next Step STEP 4 Starting aid, if necessary for cold weather, is Check for correct operation of the cold weather starting aid. Refer to Cold Weather Starting Aids in Section 1. Refer to the manufacturer's instructions. malfunctioning ............. OK Go To Next Step STEP 5 Engine block heater is malfunctioning (if equipped) ............. Check the electrical sources and wiring to the cylinder block heater. Replace the block heater, if necessary. Refer to the OEM service manual. OK Go To Next Step STEP 6 Fuel heater is malfunctioning, if equipped ............. Check the fuel heater and replace, if necessary. Refer to the manufacturer's instructions.

OK Go To Next Step STEP 7 Battery voltage is low ............. Check the batteries and the unswitched battery supply circuit. Refer to the OEM service manual. OK Go To Next Step STEP 8 Keyswitch circuit is malfunctioning ............. Check the vehicle keyswitch circuit. Refer to the OEM service manual. OK Go To Next Step STEP 9 Engine cranking speed is too slow ............. Determine if the cranking speed is slower than 150 rpm. Refer to the Engine Will Not Crank or Cranks Slowly symptom tree. OK Go To Next Step