QSB4.5 and QSB6.7 Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-29 Engine Runs Rough at Idle Cause Correction Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal symptom tree. STEP 1 Engine is cold ............. OK Go To Next Step For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. STEP 2 Electronic fault codes are active ............. OK Go To Next Step STEP 3 Idle speed is set too low for accessories ............. Check and adjust the low-idle screw.
Refer to a Cummins Authorized Repair Facility. OK Go To Next Step Check for air in the fuel system. Tighten or replace the fuel connections, fuel lines, fuel tank standpipe, and fuel filters as necessary. STEP 4 Air in the fuel system ............. OK Go To Next Step STEP 5 Fuel filter or fuel suction line is restricted ............. Replace the fuel filter. Refer to Section 5. Check the fuel suction line for restriction Section 5. OK Go To Next Step STEP 6 Fuel supply is not adequate ............. Check the flow through the filter to locate the source of the restriction. Refer to Section 5. OK Go To Next Step STEP 7 Engine mounts are worn, damaged, or not correct .............
Check the engine mounts. Refer to the OEM service manual. OK Go To Next Step STEP 8 Moisture in the wiring harness connectors ............. Dry the connectors with Cummins electronic cleaner, Part Number 3824510. OK Go To Next Step STEP 9 Fuel grade is not correct for the application or the ............. Operate the engine from a tank of high-quality fuel. Refer to Fuel Recommendations and Specifications in Section V. fuel quality is poor OK Go To Next Step STEP 10 Contact a Cummins® Authorized Repair Facility