Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-30 Section TS - Troubleshooting Symptoms Engine Runs Rough or Misfires Cause Correction Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal symptom tree. STEP 1 Engine is cold ............. OK Go To Next Step For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. STEP 2 Electronic fault codes are active ............. OK Go To Next Step Check for air in the fuel system.
Tighten or replace the fuel connections, fuel lines, fuel tank standpipe and fuel filters as necessary. Vent air from the system. Refer to Section 5. STEP 3 Air in the fuel system ............. OK Go To Next Step STEP 4 Fuel grade is not correct for the application or the Operate the engine from a tank of high-quality fuel. Refer to Fuel Recommendations and Specifications in Section V. fuel quality is poor ............. OK Go To Next Step STEP 5 Fuel leak ............. Check the fuel lines, fuel connections, and fuel filters for leaks. Refer to the OEM service manual. OK Go To Next Step STEP 6 Fuel filter is plugged ............. Measure the fuel pressure before and after the fuel filter.
Refer to Section 5. OK Go To Next Step STEP 7 Fuel supply is not adequate ............. Check the flow through the filter to locate the source of the restriction. Refer to Section 5. OK Go To Next Step STEP 8 Fuel lift pump is malfunctioning ............. Check the fuel lift pump for correct operation. Check the pump output pressure. Replace the fuel lift pump if necessary. Refer to an Authorized Cummins Repair Facility. OK Go To Next Step STEP 9 Engine mounts are worn, damaged, or not correct ............. Check the engine mounts. Refer to the OEM service manual. OK Go To Next Step