QSB4.5 and QSB6.7 Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-37 Engine Starts But Will Not Keep Running Cause Correction STEP 1 Fuel level is low in the tank ............. Fill the supply tank. Refer to the OEM service manual. OK Go To Next Step STEP 2 Battery voltage supply to the electronic control ............. Check the battery connections. Refer to the OEM service manual. module (ECM) is low, interrupted, or open OK Go To Next Step STEP 3 Electronic fault codes are active ............. For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility.
OK Go To Next Step STEP 4 Idle speed is set too low for accessories ............. Check and adjust the low-idle screw. Refer to a Cummins Authorized Repair Facility. OK Go To Next Step STEP 5 Engine-driven units are engaged ............. Disengage engine-driven units. Refer to the OEM service manual. OK Go To Next Step STEP 6 Air in the fuel system ............. Check for air in the fuel system. Tighten or replace the fuel connections, fuel lines, fuel tank standpipe, and fuel filters as necessary. OK Go To Next Step STEP 7 Fuel filter or fuel suction line is restricted ............. Replace the fuel filter. Refer to Section 5. Check the fuel suction line for restrictionSection 5.
OK Go To Next Step STEP 8 Fuel grade is not correct for the application or the ............. Operate the engine from a tank of high-quality fuel. Refer to Fuel Recommendations and Specifications in Section V. fuel quality is poor OK Go To Next Step STEP 9 Contact a Cummins® Authorized Repair Facility