Troubleshooting Symptoms Charts QSB4.5 and QSB6.7 Page TS-38 Section TS - Troubleshooting Symptoms Engine Vibration Excessive Cause Correction Check the fan hub, alternator, refrigerant compressor, and hydraulic pump for interference. Isolate belt-driven accessories and check for vibration. Refer to Section 3 and Section 4. STEP 1 Belt-driven accessories are malfunctioning ............. OK Go To Next Step STEP 2 Air compressor pumping time is excessive ............. Refer to the Air Compressor Cycles Frequently symptom tree. OK Go To Next Step STEP 3 Engine idle speed is set too low (electronically ............. Verify the correct idle speed setting.
Increase the idle speed with the idle increment switch or an electronic service tool. Refer to Section 1. controlled fuel systems) OK Go To Next Step STEP 4 Engine mounts are worn, damaged, or not correct ............. Check the engine mounts. Refer to the OEM service manual. OK Go To Next Step STEP 5 Fan is loose, damaged, or has excessive hub bearing end play ............. Check the fan. Refer to Section 3. OK Go To Next Step STEP 6 Engine is misfiring ............. Refer to the Engine Runs Rough or Misfires symptom tree. OK Go To Next Step For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility.
STEP 7 Electronic fault codes are active ............. OK Go To Next Step STEP 8 Vibration damper is damaged ............. Inspect the vibration damper. Refer to Section 7. OK Go To Next Step STEP 9 Alternator bearing worn or damaged ............. Clean and replace the alternator. Refer to the OEM service manual. OK Go To Next Step STEP 10 Contact a Cummins® Authorized Repair Facility