Cummins — 4021531

QSB4.5 and QSB6.7 Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-39 Engine Will Not Crank or Cranks Slowly (Air Starter) Cause Correction STEP 1 Air pressure is low in the air tanks ............. Increase air pressure with an external air source. Refer to the OEM service manual. OK Go To Next Step STEP 2 Engine-driven units are engaged ............. Disengage engine-driven units. Refer to the OEM Service Manual. OK Go To Next Step Check the oil level. Verify the oil pan capacity. Fill the system to the specified level. Refer to Section V. STEP 3 Lubricating oil level above specification .............

OK Go To Next Step STEP 4 Lubricating oil does not meet specifications for ............. Change the oil and filters. Refer to Section 5. Use the oil recommended in Section V. operating conditions OK Go To Next Step STEP 5 Electrical system is "open" (blown fuses, broken ............. Check the fuses, wires, and connections. Refer to the OEM service manual and manufacturer's wiring diagram. wires, or loose connections) OK Go To Next Step STEP 6 Battery charge is low ............. Check battery. If the battery is low, check the alternator for proper charging. Charge the battery, and replace if necessary. Refer to the OEM service manual.

OK Go To Next Step STEP 7 Keyswitch circuit is malfunctioning ............. Check the vehicle, equipment, or vessel keyswitch circuit. Refer to the OEM service manual. OK Go To Next Step STEP 8 Starter solenoid is not receiving voltage ............. Check the battery supply to the starter solenoid. Refer to the OEM service manual. OK Go To Next Step STEP 9 Starting motor is malfunctioning or starting motor is Check the starting motor operation. Compare the starting motor with the engine and vehicle specifications. Refer to the manufacturer's instructions. ............. not correct OK Go To Next Step