Cummins — 4021531

QSB4.5 and QSB6.7 Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-55 Lubricating Oil Loss Cause Correction Inspect the engine for external oil leaks. Tighten the capscrews, pipe plugs, and fittings. Replace gaskets, if necessary. Refer to the OEM service manual. STEP 1 Lubricating oil leak (external) ............. OK Go To Next Step Check the oil level. Verify the dipstick calibration and the oil pan capacity. Fill the system to the specified level. Refer to Section V. STEP 2 Lubricating oil level is below specification ............. OK Go To Next Step STEP 3 Lubricating oil does not meet specifications for ............. Change the oil and filters.

Refer to Section 5. Use the oil recommended in Section V. operating conditions OK Go To Next Step STEP 4 Lubricating oil pressure switch, gauge, or sensor is ............. Check the oil pressure switch, gauge, or sensor for correct operation and location. Refer to an Authorized Cummins Repair Facility. malfunctioning or is not in the correct location OK Go To Next Step For instructions on how to read active fault codes, refer to Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. STEP 5 Electronic fault codes are active ............. OK Go To Next Step Check the lubricating oil cooler for coolant leaks and cracks.

Refer to the OEM service manual or an Authorized Cummins Repair Facility. STEP 6 Lubricating oil cooler is leaking ............. OK Go To Next Step STEP 7 Air compressor is pumping lubricating oil into the ............. Check the air lines for carbon buildup and lubricating oil. Refer to the OEM service manual or an Authorized Cummins Repair Facility. air system OK Go To Next Step STEP 8 Blowby excessive ............. Check for excessive blowby. Refer to the OEM service manual or an Authorized Cummins Repair Facility. OK Go To Next Step