Cummins — 4021531

QSB4.5 and QSB6.7 Electronic Controlled Fuel System Section 1 - Operating Instructions Page 1-9 Engine Protection System The engines are equipped with an engine protection system. The system monitors critical engine temperatures and pressures and will log diagnostic faults when an over or under normal operation condition occurs. If an out-of- range condition exists and engine derate action is to be initiated, the operator will be alerted by an in-cab WARNING lamp. The WARNING lamp will blink or flash when out-of-range conditions continue to worsen.

When the red STOP lamp is illuminated, the driver must pull to the side of the work area, when it is safe to do so, to reduce the possibility of engine damage. NOTE: Engine power and speed will be gradually reduced, depending on the level of severity of the observed condition. The engine protection system will not shutdown the engine unless the engine protection shut down feature has been enabled. Engine Protection Shutdown This feature automatically shuts off the engine when the temperature, pressure, and coolant level sensors indicate the engine is operating over or under normal operating conditions.

The red STOP lamp in the cab will flash for 30 seconds prior to shut down to alert the driver. Engine Protection Shutdown Manual Override This feature allows the operator to override a pending engine shutdown. Prior to engine shutdown, the red STOP lamp will flash for 30 seconds to notify the operator that the engine is about to shut down. The operator can override the engine shut down through use of an OEM switch, such as the clutch switch. If the vehicle is not equipped with a clutch switch, then the OEM will provide a dash-mounted switch marked as the ENGINE PROTECTION SHUTDOWN OVERRIDE switch.

When the operator triggers this switch while the red lamp is flashing, a timer within the ECM will reset and allow the engine to operate for an additional 30 seconds before engine shutdown occurs. Each time the operator triggers the override switch, the timer within the ECM is reset, allowing the engine to operate for an additional 30 seconds.