Electronic Controlled Fuel System QSB4.5 and QSB6.7 Page 1-10 Section 1 - Operating Instructions Diagnostic Fault Codes The control system can show and record operation anomalies that present themselves as fault codes. These codes will make troubleshooting easier. The fault codes are recorded in the ECM. They can be read using the fault lamps in the dash or with INSITE™ electronic service tool. NOTE: Not all engine or control system anomalies are shown as fault codes. There are three types of system codes: Engine electronic control system fault codes Engine protection system fault codes Engine maintenance indicator codes.
All fault codes recorded will either be active (fault code is currently active on the engine) or inactive (fault code was active at some time, but is not active at the moment). Most of the electronic fault codes will light a lamp when they are active. There are three possible lamps that can be lit when a fault is active: The WARNING or CHECK ENGINE lamp is yellow and indicates the need to repair the fault at the first available opportunity. The STOP or STOP ENGINE lamp is red and indicates the need to stop the engine as soon as it can be safely done. The engine should remain shut down until the fault can be repaired.
The MAINTENANCE or FLUID lamp will illuminate when an engine maintenance function needs to be performed. NOTE: The names and colors of these lamps can vary by equipment manufacturer.