Cummins — 4021531

QSB4.5 and QSB6.7 Electronic Controlled Fuel System Section 1 - Operating Instructions Page 1-11 Some vehicles will also have a WAIT-TO-START lamp and a WATER-IN-FUEL lamp. The WAIT-TO-START lamp is illuminated during the preheating time that takes place at keyswitch ON during cold-weather starting. To minimize cranking time during cold-weather starting, the engine should not be cranked until the WAIT-TO-START lamp has been extinguished. The WATER-IN-FUEL lamp indicates that the engine's water-in-fuel separator needs to have the water drained out of it. This task should be performed as soon as possible whenever this lamp is illuminated.

Some vehicle manufacturers will combine the functions of the MAINTENANCE and WATER-IN-FUEL lamps. In these cases, the MAINTENANCE lamp would indicate a WATER-IN-FUEL warning, in addition to other maintenance indicators. There are two ways to check for active engine electronic fuel system fault codes and maintenance indicator codes, depending on whether the engine is equipped with a diagnostic switch. Vehicle with Diagnostic Switch Turn the keyswitch to the OFF position. Move the diagnostic switch to the ON position, or connect the shorting plug into the diagnostic connector. Turn the vehicle keyswitch to the ON position.

Vehicle without Diagnostic Switch Turn the vehicle keyswitch to the ON position. With the keyswitch on and the engine not operating, cycle the accelerator pedal to full throttle and back to the idle position three times. If no active fault codes are recorded, both lights will come on and stay on. If active fault codes are recorded, both lights will come on momentarily, then begin to flash the code of the recorded fault(s).