Drive Belts QSB4.5 and QSB6.7 Page 3-4 Section 3 - Maintenance Procedures at Daily Interval Lubricating Oil Level Maintenance Check Never operate the engine with oil level below the L (low) mark or above the H (high) mark. Poor engine performance or engine damage can occur. CAUTION The engine must be level when checking the oil level to make sure the measurement is correct. Shut off the engine for an accurate reading. Wait at least 15 minutes after shutting off the engine to check the oil level. This allows time for the oil to drain into the oil pan. For additional lubricating oil recommendations and oil pan capacity information, refer to Maintenance Specifications (Section V).
Drive Belts Maintenance Check Poly-Vee Belt Make sure that the engine is switched off and any starting mechanisms are isolated before any inspections are made. Daily belt inspections can be carried out through an appropriate aperture. Do not remove any guards. CAUTION Inspect the belts daily. Check the belt for intersecting cracks. Traverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing. Refer to Section A for belt adjustment and replacement procedures. Belt damage can be caused by:
Incorrect tension Incorrect size or length Pulley misalignment Incorrect installation Severe operating environment Oil or grease on the side of belts.