Cooling System QSB4.5 and QSB6.7 Page 5-6 Section 5 - Maintenance Procedures at 500 Hours or 6 Months Do not stand near the surge tank or radiator while operating the engine with the pressure cap off. If the vehicle is equipped with a fill door on side of the surge tank, keep it closed due to coolant expansion. WARNING Do not operate the engine with the pressure cap off a temperatures above 93°C [200°F]. This can result in potential engine damage by cavitation of the water pump and localized boiling. NOTE: Do not install the radiator cap. CAUTION Fill the cooling system with good quality water to the capacity or level stated in the OEM service manual.
Unless indicated otherwise by OEM instructions, it is critical that all shutoff valves be returned to their open positions once the system has been refilled and the deaeration process is about to begin. This will help to make sure as much air as possible will be purged from the cooling system. See the OEM service manual for valve locations. Wait 2 to 3 minutes, without starting the engine, to allow the system to naturally purge entrained air and the coolant level to stabilize. Add plain water to bring the level back to FULL. Turn all cab heater switches to HIGH in order to allow maximum coolant flow through heater core(s). The blower MUST be turned ON.
With the cooling system fill cap removed: Operate the engine at LOW IDLE for 2 minutes. Turn off the engine and add plain water to bring the level back to FULL. With the cooling system fill cap removed: Start the engine Operate the engine at HIGH IDLE until the thermostat opens. NOTE: After starting a cold engine, increase the engine speed (rpm) slowly to provide adequate lubrication to the bearings and to allow the oil pressure to stabilize. Allow the engine to return to LOW idle for 2 minutes before shutting it down. This allows adequate cool down of pistons, cylinders, bearings, and turbocharger components.