Cooling System QSB4.5 and QSB6.7 Page 5-8 Section 5 - Maintenance Procedures at 500 Hours or 6 Months Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [122°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Do not stand near the surge tank or radiator while operating the engine with the pressure cap off. If the vehicle is equipped with a fill door on side of the surge tank, keep it closed due to coolant expansion. WARNING CAUTION Do not operate the engine with the pressure cap off a temperatures above 93°C [200°F].
This can result in potential engine damage by cavitation of the water pump and localized boiling. CAUTION Topping off the system while hot is not recommended when using the fill door on transit bus applications equipped with surge tanks. Bringing the level to the bottom of the door while the system is hot will not provide adequate volume of coolant for lower operating temperatures. This can result in cavitation of the water pump and greatly increase the potential for engine damage. Before topping off coolant, allow the system temperature to cool to ambient. This will make sure that an adequate amount of coolant is available to the water pump during all periods of operation.
CAUTION CAUTION Engine and component damage may result if adequate cool down time is not given after the cooling system pressure has been relieved in order to "top off". System pressure is ONLY generated with temperature rise of the coolant, closing the cooling system while hot will not allow for pressure to build. Remove the cooling system fill cap. Fill the cooling system to the capacity or level stated in the OEM service manual, using a mixture of 50 percent water and 50 percent ethylene glycol or propylene glycol antifreeze.