Radiator Pressure Cap QSB4.5 and QSB6.7 Page 5-14 Section 5 - Maintenance Procedures at 500 Hours or 6 Months Idle the engine to inspect for leaks at the drain plug and, if replaced, the oil filter seal. NOTE: Engine oil pressure must be indicated on the gauge within 15 seconds after starting. If oil pressure is not registered within 15 seconds, shut off the engine immediately to avoid engine damage. Confirm that the correct oil level is in the oil pan. Shut off the engine. Wait approximately 5 minutes to let the oil drain from the upper parts of the engine. Check the level again. Add oil as necessary to bring the oil level to the H (high) mark on the dipstick.
Radiator Pressure Cap General Information The cooling system is designed to use a pressure cap to prevent boiling of the coolant. Refer to the OEM's cooling system specifications for the correct radiator pressure cap for your application. An incorrect or malfunctioning cap can result in the loss of coolant and the engine running hot. Inspect for Reuse Be sure the correct radiator pressure cap is being used. Inspect the rubber seal of the pressure cap for damage. Inspect the radiator fill neck for cracks or other damage. Refer to the OEM service manual for instructions if the fill neck is damaged.