Komatsu — 17. GUIDES TO MAINTENANCE

17. GUIDES TO MAINTENANCE Check service meter: Check the service meter reading every day to see if the time has come for any necessary maintenance to be carried out. Komatsu genuine replacement parts: Use Komatsu genuine parts specified in the Parts Book as replacement parts. Komatsu genuine oils: Use Komatsu genuine oils and grease. Choose oils and grease with proper viscosities specified for ambient temperature. Always use clean washer fluid: Use automobile window washer fluid and be careful not to let any dirt get into it. Always use clean oil and grease: Use clean oil and grease. Also, keep containers of the oil and grease clean. Keep foreign materials away from oil and grease.

Keeping the machine clean: Always keep the machine clean. This makes is easier to find parts causing problems. In particular, keep grease fittings, breathers and oil level gauges clean and avoid foreign materials from getting in them. After disconnecting the connector, cover it with a vinyl bag to prevent oil or dust from sticking to its contact section. Be careful of hot water and oil: Draining hot oils and coolants and removing their filters immediately after the engine stops are hazardous. Allow the engine to cool. If the oil has to be drained when it is cold, warm up the oil to a suitable temperature (approx. 20 – 40°C) before draining it.

Checking foreign materials in drained oil and on filters: After oil is changed or filters are replaced, check the oil and filters for metallic particles and foreign materials. If large quantities of metallic particles or foreign materials are found, consult your Komatsu distributor. Fuel strainer: If your machine is equipped with a fuel strainer, do not remove it while fueling. Oil change: Check or change oils in the places where dust is scarce to keep foreign materials away from oils. Warning tag: Attach the warning tag to the starting switch or other appropriate control lever to prevent anyone from starting the engine during maintenance. Obey precautions:

During the operation, always obey the precautions on the safety label attached to the machine. Welding instructions: Turn off the engine starting switch. Do not apply more than 200 V continuously. Connect grounding the cable within 1 m (3.28 ft) from the area to be welded. Avoid seals or bearings from being between the area to be welded and the position of the grounding point. Never weld any pipe or tube containing fuel or oil. 3-3