Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.10 REPLACE BUCKET TEETH WARNING It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine, apply the parking brake and locks securely to the work equipment control levers. If the bucket equipped with tip tooth. Replace the teeth before they wear down as far as the adaptor. 1. Extract pin 2 fitted to the bucket and then remove tooth 1 . When extracting pin 2 , strike the part (either the left or right part) with a sharp object. This will enable the pin to be extracted from the opposite side. 2.

Insert the new tooth 1 into the adaptor 3 , and insert pin 2 partway as shown in the diagram. Then drive it home by means of a hammer. 3. After operating the machine for a few hours, check that the pin does not come out. 3-32