Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.7 CLEAN CONDENSER OF AIR CONDITIONER WARNING Do not wash the condenser with a steam cleaner. Otherwise, the condenser will get hot and may break down. Open inspection cover 1 on the top of the floor and remove 3 bolts from cover 2 of the air condenser. If there is mud or dust on the air conditioner condenser, clean it with water. Check the fins for clogging or damage. If the water pressure is too high, the fins may get deformed. When washing with a high pressure washing machine, apply the water from a reasonable distance. Use water to wash off any mud stuck to the condenser. If necessary, use a soft brush. Do not use a hard brush, as this will damage the fins.

24.2.8 CLEAN RADIATOR FINS Carry out this procedure if there is any mud or dirt seen stuck to the radiator. 1. Remove bolt 1 and open radiator grill 2 , then apply the lock securely. 2. Use compressed air to clean the mud dust, and leaves from the radiator fins. Steam or water may be used instead of com- pressed air. NOTICE If the steam nozzle is brought too near the radiator fins, the fins may be damaged. Accordingly, keep the nozzle away from the fins. 3. The rubber hose should be checked at the same time. If the hose is found to have cracks or to be hardened by ageing, it should be replaced with a new one. Further, loosen hose clamps should also be tightened.

24.2.9 CHECK ELECTRICAL INTAKE AIR HEATER Check the electrical intake air heater once a year before com- mencing work in the cold season. Remove the electrical intake air heater from the engine intake connection, and check it for possible open-circuits and dirt. When inspecting and replacing the electrical intake air heater, replace the gasket with a new one. Ask your Komatsu distributor to check electrical intake air herater. 3-31