Komatsu — 24.6 EVERY 250 HOURS SERVICE

24. SERVICE PROCEDURE 24.6.2 CHECK ALTERNATOR BELT TENSION, ADJUST Checking The belt should normally deflect by about 20 mm (0.79 in) when pressed with the finger (with a force of approx. 58.8N (6 kgf) at a point midway between the drive pulley and alternator pulley. Adjusting 1. Loosen bolt 1 , 2 , 3 and lock nut 5 . 2. Rotate adjusting nut 4 so that the deflection is approx. 20 mm (0.79 in) (at a force of approx. 58.8 N (6 kgf)). 3. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 4.

Replace the V-belt if it has stretched, leaving no allowance for adjustment, or if there is any cut or crack on belt. 5. After adjustment, tighten lock nut 5 and bolt 2 , 3 securely. 6. After operating the machine for one hour with a newly ex- changed V-belt, test and adjust the V-belt again. 3-58