24. SERVICE PROCEDURE 7. Using the filter wrench, turn 4 full-flow filter cartridges 2 and 2 bypass filter cartridges 3 to the left to remove them. In particular, if this operation is carried out immediately after stopping the engine, a large amount of oil will come out, so wait for 10 minutes before starting the operation. 8. Clean the filter holder, fill the new filter cartridge with engine oil, then coat the seal and thread of the filter cartridge with engine oil (or coat thinly with grease) and install. 9. When installing, bring the seal surface into contact with the filter holder, then tighten a further 3/4 – 1 turns. 10.
After replacing the filter cartridge, add engine oil through oil filler F until the oil level is between the H and L marks on dipstick G . For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 11. Run the engine at idling for a short time, then stop the engine, and check that the oil level is between the H and L marks on the dipstick. For details, see “24.3 CHECK BEFORE STARTING”. 3-62