Komatsu — 24.7 EVERY 500 HOURS SERVICE

24. SERVICE PROCEDURE 24.7.2 REPLACE FUEL FILTER CARTRIDGE WARNING Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. Do not bring fire or sparks near the fuel. Prepare a filter wrench and a container to catch the fuel. 1. Open the side panel located on the right of the machine and lock the open lock. 2. Set the container to catch the fuel under the filter cartridge. Turn fuel stop lever 1 toward you to prevent the fuel from dripping. 3. Using a filter wrench, turn filter cartridge 2 counterclockwise to remove it. 4.

Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. 5. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 1/2 to 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. 6. After replacing filter cartridge 2 , fully open fuel stop lever 1 , then loosen air bleed plug 4 . 7.

Loosen feed pump knob 3 and move the pump up and down to draw off fuel until air ceases to come out of air bleed plug 4 . 8. After bleeding air, tighten air bleed plug 4 , then push in the knob of feed pump 3 and tighten it. WARNING When cranking the engine, confirm the safety around the en- gine, as the engine may start. 9. After replacing the filter cartridge, turn the key in the starting switch to the START position. When the engine starts, check for any leakage from the filter seal surface. If there is any leakage, check the tightening of the filter cartridge.

If there is still any leakage, follow the procedure in Steps 2 and 3 to remove the filter cartridge, and check the packing surface. If there is any damage or any dirt or dust caught in the surface, replace the packing with a new part, then repeat Steps 4 to 8 to install again. 3-63