. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING final drive REMARK There is a cast OIL LEVEL display on the cover, but there is no need to return it to the horizontal position. REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING Replace the element when the oil is cold. When removing breather cap (1), turn it slowly to release the internal pressure before removing it. 4 - 64 There is danger that oil may spurt out under internal pressure , so stan d to the side, and gradually turn t pressure before removing t 1. Place the machine o n a horizontal place. g (G) and check whether th 2. Remove oil level plu case is filled with oil to lower edge of the plug hole 3.
If the oil level is still too low, add gear oil through oil filter plug hole (F) until the oil overflows. Before removing oil plug (F), remove all the mud a nd dirt f rom around oil filler plug ( F). Be careful not to let any dirt or sand get in when adding oil. 1. Remove breather ca p (1) on the top of the hydrau lic tank. 2. Replace element (2)