. MAINTENANCE SERVICE PROCEDURE CHECK, REPLACE DRIVE BELT FOR ALTERNATOR, AIR CONDITIONER COMPRESSOR no REPLACE 4 - 65 CHECK If the alternator d rive belt is in any of t he following conditions, belt mus t be replaced When horizont al scratc h (1) crosse s vertical scratch (2) When there ar e tears (3 ) in part of t he belt In case (4) where there ar need to replace t only, there i 1. Loosen lockn ut (2 ) of p ush bolt (1), then screw in push bolt fully and loosening tension pulley. 2. Replace the b elt. Loosen can be push seen, bolt then (1) until tighten approx. locknut 90 (2)