Arctic Cat TRV — Arctic Cat TRV User Manual

ATV Operation Starting a Cold Engine 2. To engage the P (park), come to a complete stop; then shift the trans- mission into park. NOTE: It is very important not to touch or compress the throttle lever during the starting procedures. NOTE: The high range is for nor- mal riding with light loads. The low range is for carrying heavy loads or trailer towing. Compared to HIGH range, the LOW range posi- tion provides slower speed and greater torque to the wheels. 1. Turn off all electrical accessories (hand warmer, lights, etc.); then with the transmission in the neutral posi- tion, rotate the ignition switch key to the first position (ON) leaving the headlights OFF.

Note that the N is indicated on the LCD. 2. Press the starter button. CAUTION Always shift into low range when oper- ating on wet or uneven terrain, when towing or pushing heavy loads, and when using a plow. Failure to follow this caution may result in premature V- belt failure or in damage to related drive system components. CAUTION Do not run the starter motor for more than eight seconds per starting attempt. The starter motor may over- heat causing severe starter motor damage. Allow 15 seconds between starting attempts to allow the starter motor to cool. Braking/Stopping Always allow plenty of room and time to stop safely. Sometimes quick stops are inevitable, so always be prepared.

Whether you’re stopping slowly or stop- ping quickly, do this: NOTE: Do not touch the throttle lever until the engine has run for at least 3 minutes. 3. If the engine does not start, press the starter button again for eight seconds. 1. Squeeze the brake lever on the left handlebar to apply both the front and rear brakes. 4. Allow the engine to warm up for approximately 2-3 minutes or until the ATV will accelerate without hesitating. 2. If your wheels lock, release them for a second; then apply them again. Shifting ! WARNING 1. To engage any gear position from park, move the shift lever upward to the desired position: R (reverse), N (neutral), H (high range), or L (low range).

Excessive repetitive use of the hydraulic brake for high speed stops will cause overheating of the brake fluid and premature brake pad wear which will result in an unexpected loss of brakes. 3. Never “ride” the brake. Even main- taining minimal pressure on the brake lever will cause the brake pads to drag on the disc and may overheat the brake fluid. EFI012A 39