Speedometer/LCD NOTE: When the bottom segment flashes, approximately 3.5 L (0.92 U.S. gal.) of gasoline remains in the tank. Limited 3. Mode Button - Press and release to shift the gauge between MPH or km/h and RPM. Press and hold to switch beetween MPH and km/h. 4. Set/Reset Button - Press and release to shift betwen Odometer, Trip 1, Trip 2, Engine Hour Meter, and Clock. Press and hold while Trip 1 or Trip 2 are selected to clear the selected trip. The odometer cannot be reset. EFI013A TRV/XT 5.
Odometer/Trip Meter/Clock/Engine Hour Meter - Displays odometer (total distance the vehicle has trav- eled) or one of two trip meters used to measure trips or trip legs correspond- ing to the function selected (MPH or km/h). The clock function indicates time in the 12 hour mode. The hour meter indicates the total time the ATV has run and cannot be reset to zero. To set the clock, use the following procedure. EFI011B 1. Speedometer/Tachometer/Condition Warning Display - Indicates the approximate vehicle speed (MPH or km/h) or RPM. Warns of a system error condition requiring attention. A.
With the ignition switch ON, press and release the Mode Button (3) until the Clock/Engine Hour Meter (1) is displayed; then (if necessary) press and release the Set/Reset Button (4) to the clock display. The LCD will go blank except the word VOLT will flash on the LCD whenever a low voltage ( or a high voltage (>16 DC volts) is detected. When voltage returns to nor- mal, the gauge must be reset by turning the ignition key to the OFF position and then to the ON position. B. Press and hold Set/Reset Button (4) until minutes stop scrolling and the hour display starts to scroll.
Momentarily release when correct hour is displayed; then repeatedly press and release Set/Reset Button until correct minutes are displayed. The letters EFI (digital/analog gauge) or a diagnostic trouble code (DTC) (digital gauge) will flash on the LCD whenever an EFI system error is detected. After 30 seconds, the gauge will return to normal, but the letters or code will continue to flash until the malfunction is corrected. NOTE: Approximately two seconds after releasing either Button, the LCD will return to normal operation. NOTE: Clock memory power is supplied through the 15-amp acces- sory fuse and verified during gauge “power-up” and reset.
In the event of clock memory power failure (blown fuse, etc.), the gauge will “power- up,” reset, and shut down repeatedly until clock memory power is restored. Always check the 15-amp accessory fuse if this gauge condi- tion is noted. NOTE: Take the ATV to an autho- rized Arctic Cat ATV dealer to have the error corrected and the system error reset as soon as possible. 2. Fuel Level Indicator - Indicates approximate amount of gasoline in the gas tank. 54