NOTE: The engine hour meter will not activate until engine speed exceeds 500 RPM. NOTE: Debris in front of the engine (or packed between the cooling fins of the radiator) can reduce cooling capacity. Using a garden hose, wash the radiator and the engine to remove any debris restricting air flow. 6. Gear Position Indicator - Indicates which gear is selected - R (reverse)/N (neutral)/H (high range)/L (low range)/P (park). CAUTION NOTE: An E will be displayed if there is an error caused by a no-shift position signal. Arctic Cat does not recommend using a pressure washer to clean the radiator core.
The pressure may bend or flatten the fins causing restricted air flow, and electrical components on the radiator could be damaged. Use only a garden hose with spray nozzle at normal tap pressure. 7. Engine Hour Meter Indicator - Indi- cates engine hour meter mode is selected on the display. 8. Speedometer/Tachometer Indicator - Indicates which mode (MPH, km/h, or RPM) is being displayed. 13. Odometer/Trip Meter Indicator Dis- play - Displays which function (ODO, Trip, or Trip 2) is selected. 9. 4WD Lock Indicator - Displays LOCK when the front differential lock has been engaged. 14.
Speedometer/Tachometer Needle (digital/analog gauge) - Indicates approximate vehicle speed in MPH or km/h when speedometer function is selected or RPM when tachometer function is selected. Sweeps full-scale whenever an EFI system error is detected. 10. Drive Select Indicator - Displays 4WD when selected by the drive select switch or when the 4WD lock is engaged. The display is blank when in 2WD. 11. High Beam Indicator - Appears when the headlights are on high beam. Wrench Indicator (digital gauge) - Displayed in conjunction with a DTC whenever an EFI system error is detected. 12.
Temperature Indicator - The speedom- eter/tachometer needle will sweep full scale and the LCD will go blank except the high temperature icon will flash. After 30 seconds, the speedometer/ tachometer needle and LCD will return to normal, but the temperature icon will continue to flash. The icon should not be visible during normal operation. Electric Fuel Pump An electric fuel pump is incorporated in the gas tank to deliver gasoline to the fuel injector. The fuel pump is activated when the ignition switch is in the ON position. CAUTION NOTE: Both the ignition and fuel pump functions will be interrupted by the Tilt Sensor if the ATV tips over past 60°-70°.
Righting the ATV will reactivate the ignition and fuel pump. Continued operation with high engine temperature may result in engine damage or premature wear. NOTE: High engine RPM, low vehi- cle speed, or heavy load can raise engine temperature. Decreasing engine RPM, reducing load, and selecting an appropriate transmis- sion gear can lower the temperature. Oil Level Stick There is an oil level stick for checking the engine oil level. To check the oil level, use the following procedure. NOTE: The ATV should be on level ground when checking the engine oil level. 55