1. Unscrew the oil level stick and wipe it with a clean cloth. Mirrors (Limited) 2. Install the oil level stick and thread it completely into the engine case. The mirrors can be adjusted to the desired viewing angle or moved to a stowed posi- tion when operating in trees or brush. 3. Remove the oil level stick; the engine oil level should be within the operat- ing range but not above the FULL mark. ! WARNING Always adjust the mirrors to a position that will not catch tree branches or under-brush which could cause a loss of control and severe injury or death. Rear Seat Lock 1. To remove the rear seat, pull the two latch handles to the rear and rotate them to the vertical position.
CAUTION GZ461A Do not overfill the engine with oil. Always make sure the oil level is within the operating range. Windshied (Limited) CR017D 2. Lift the rear of the seat up; then pull slightly to the rear and lift the seat off the mountings. CAUTION Remove the windshield before traile- ring the ATV or damage to the wind- shield may occur. 3. To lock the seat into position, engage the two front mounting lugs into the mounting rack; then, holding down firmly on the front of the seat, push the seat forward until the rear tabs engage the rear mounting latches. To remove the windshield, loosen the left and right plastic knobs and remove the wind- shield assembly.
Tighten the knobs securely or remove them completely to prevent loss. 4. Lock the seat into position by rotat- ing the latch handles to the horizon- tal position; then push the handles forward to lock. CR003 To install the windshield, loosen the left and right plastic knobs; then install the tapered windshield pins into the mounts and tighten knobs securely. CR017E 56