Liquid Cooling System The cooling system should be inspected daily for leakage and damage. If leakage or damage is detected, take the ATV to an authorized Arctic Cat ATV dealer for ser- vice. Also, the coolant level should be checked periodically. When filling the cooling system, use a coolant/water mixture which will satisfy the coldest anticipated weather condi- tions of the area in accordance with the coolant manufacturer’s recommenda- tions. While the cooling system is being filled, air pockets may develop; there- fore, run the engine for five minutes after the initial fill, shut the engine off, and then fill the cooling system to the bottom of the stand pipe in the radiator neck.
CF134A 2. Lift the front of the access panel; then slide the panel forward to dis- engage the two rear tabs. NOTE: Use a good quality, biode- gradable glycol-based, automo- tive-type antifreeze. CAUTION After operating the ATV for the initial 5-10 minutes, stop the engine, allow the engine to cool down, and check the coolant level. Add coolant as nec- essary. CF133A 3. Move the panel rearward until free of the rack. 4. Carefully rotate the radiator cap counterclockwise to release pres- sure; then remove the cap. ! WARNING Never check the coolant level when the engine is hot or the cooling sys- tem is under pressure. NOTE:
High engine RPM, low vehicle speed, or heavy load can raise engine temperature. Decreasing engine RPM, reducing load, and selecting an appropriate transmission gear can lower the temperature. CF142A To check/add coolant, use the following procedure. 5. Add coolant as necessary; then install the radiator cap and access panel. 1. Remove the two reinstallable rivets from the front of the radiator access panel. Oil Cooler (1000) NOTE: Dirt and debris must be cleaned from cooling fins regularly to ensure proper engine oil cooling. 62