CAUTION Continued operation of the ATV with high engine temperature may result in engine damage or premature wear. NOTE: High engine RPM, low vehi- cle speed, or heavy load can raise engine temperature. Decreasing engine RPM, reducing load, and selecting an appropriate transmis- sion gear can lower the temperature. NOTE: Before attempting to adjust suspension, clean dirt and debris from the sleeve and remove load from the suspension; then use the spanner wrench to adjust the sleeve to the desired position. NOTE: It is recommended that all ATV weight be taken off the sus- pension prior to adjusting shock absorber sleeves.
Shock Absorbers Each shock absorber should be visibly checked weekly for excessive fluid leak- age (some seal leakage may be observed but it does not indicate the shock is in need of replacement), cracks or breaks in the lower case, or a bent shock rod. If any one of these conditions is detected, replacement is necessary. General Lubrication NOTE: When the ATV is oper- ated in extremely cold weather (-23°C/-10°F or colder), a small amount of leakage may be pres- ent. Unless the leakage is excessive, replacement is not necessary. Cables None of the cables require lubrication; however, it is advisable to lubricate the ends of the cables periodically with a good cable lubricant.
Engine/Transmission Oil and Filter The shock absorber has a spring force adjustment sleeve with five adjustment positions to allow the spring to be adjusted for different riding and loading conditions. If the spring action is too soft or too stiff, adjust it according to the chart. Change the engine oil and oil filter at the scheduled intervals. The engine should always be warm when the oil is changed so the oil will drain easily and completely. 1. Park the ATV on level ground. 2. Remove the oil level stick/filler plug. Be careful not to allow con- taminates to enter the opening. CD453 CF109P 63 Position Spring Force Setting Load 1 Stronger Soft Stiff Light Heavy 2 3 4 5