Brake Lever Lock CF113A 6. Install the filler plugs. CF301A Check to make sure the brake lever lock engages properly and that the brake (when engaged) locks the wheels. Hydraulic Hand Brake ! WARNING Be sure to inspect the hydraulic brake system before each use. Always maintain brakes according to the Maintenance Schedule. 1. Pump the brake lever 2 or 3 times. 2. Engage the brake lever lock. 3. Attempt to push the ATV. Brake Fluid NOTE: The brake lever lock must lock the wheels. If it doesn’t, take the ATV to an authorized Arctic Cat ATV dealer for service. Check the brake fluid level in the brake fluid reservoir.
If the level in the reser- voir is not visible in the sight glass, add DOT 4 brake fluid. Brake Hoses Carefully inspect the hydraulic brake hoses for cracks or other damage. If found, take the ATV to an authorized Arctic Cat ATV dealer to have the brake hoses replaced. Brake Pads The clearance between the brake pads and brake discs is adjusted automatically as the brake pads wear. The only mainte- nance that is required is replacement of the brake pads when they show excessive wear. Check the thickness of each of the brake pads as follows: CF295A NOTE: If the sight glass appears dark, there is a sufficient amount of fluid in the reservoir. CAUTION 1. Remove a front wheel. 2.
Measure the thickness of each brake pad. Be careful not to spill any fluid when filling the brake fluid reservoir. Wipe away spilled fluid immediately. 3. If thickness of either brake pad is less than 1.0 mm (0.039 in.), take the ATV to an authorized Arctic Cat ATV dealer to have brake pads replaced. 65