Protective Rubber Boots The protective boots should be inspected periodically according to the Mainte- nance Schedule. Ball Joint Boots (Upper and Lower/Right and Left) PR376B 4. Install the wheel and tighten using a crisscross pattern in 20 ft-lb incre- ments to 40 ft-lb (steel wheels) or 80 ft-lb (aluminum wheels). Rear Foot Brake The rear foot brake must be properly maintained to be fully functional. CC791 1. Secure the ATV on a support stand to elevate the front wheels. ! WARNING Be sure to inspect the rear foot brake system before each use. Always maintain brakes according to the Maintenance Schedule. 2. Remove both front wheels. 3.
Inspect the four ball joint boots for cracks, tears, or perforations. 1. Check the brake fluid level in the res- ervoir. The fluid level must be main- tained between the MAX and MIN level marks. If the level in the reser- voir is low, add DOT 4 brake fluid. 4. Check the ball joint for free-play by grasping the steering knuckle and turning it from side to side and up and down. 5. If boot damage is present or ball joint free-play seems excessive, con- tact an authorized Arctic Cat ATV dealer for service. Tie Rod Boots (Inner and Outer/Right and Left) CD474A NOTE: The brake fluid reservoir is located on the electrical panel beneath the operator’s seat. 2.
Press the rear foot brake several times to check for firmness. CC792 1. Secure the ATV on a support stand to elevate the front wheels. 3. If the brake is not firm, the system must be bled. NOTE: Take the ATV to an autho- rized Arctic Cat ATV dealer for this service. 2. Remove both front wheels. 66