Jump-Starting CAUTION NOTE: Arctic Cat does not rec- ommend jump-starting a vehicle with a dead battery but rather to remove the battery, service it, and correctly charge it; however, in an emergency, it may be necessary to jump-start a vehicle. If so, use the following procedure to carefully and safely complete this procedure. Always make sure the electrical sys- tems are of the same voltage and ground polarity prior to connecting jumper cables. If not, severe electri- cal damage may occur. 4.
Move the vehicle to be used for the jump-start close enough to ensure the jumper cables easily reach; then shift into neutral, set and lock the brakes, shut off all electrical acces- sories, and turn the ignition switch OFF. ! WARNING Improper handling or connecting of a battery may result in severe injury including acid burns, electrical burns, or blindness as a result of an explo- sion. Always remove rings and watches. NOTE: Make sure all switches on the vehicle to be jump-started are turned OFF. 5. Disconnect all external accessories such as cell phones, GPS units, and radios on both vehicles. 1. On the vehicle to be jump-started, remove the battery cover and any terminal boots. CAUTION !
WARNING Failure to disconnect electronic accessories during jump-starting may cause system damage due to power spikes. Any time service is performed on a battery, the following must be observed: keep sparks, open flame, cigarettes, or any other flame away. Always wear safety glasses. Protect skin and clothing when handling a battery. When servicing a battery in an enclosed space, keep the area well-ventilated. Make sure battery venting is not obstructed. 6.
Attach one clamp of the positive (red) jumper cable to the positive (+) terminal (1) of the dead battery (C) being careful not to touch any metal with the other clamp; then attach the other clamp of the positive (red) jumper cable to the positive (+) ter- minal (2) of the good battery (B). 2. Inspect the battery for any signs of electrolyte leaks, loose terminals, or bulging sides. Leaking or bulging battery cases may indicate a frozen or shorted battery. ! WARNING If any of these conditions exist, DO NOT attempt a jump-start, boost, or charge the battery. An explosion could occur causing serious injury. 0744-527 3.
Inspect the vehicle to be used for jump-starting to determine if voltage and ground polarity are compatible. The vehicle must have a 12-volt DC, negative ground electrical system. NOTE: Some jumper cables may be the same color but the clamps or ends will be color-coded red and black. 69