Arctic Cat TRV — Arctic Cat TRV User Manual

7. Attach one clamp of the negative (black) jumper cable to the negative (-) terminal (3) of the good battery (B); then attach the other clamp of the nega- tive (black) jumper cable (4) to an unpainted metal surface (A) on the engine or frame well away from dead battery and fuel system components. ! WARNING Never make the final connection to a battery as a spark could ignite hydro- gen gases causing an explosion of the battery resulting in acid burns or blindness. ATV-0051 Adjust the gap to specification for proper ignition (see appropriate specification chart). Use a feeler gauge to check the gap. 8. Stand well away from the dead bat- tery and start the vehicle with the good battery.

Allow the vehicle to run for several minutes applying some charge to the dead battery. 9. Start the vehicle with the dead bat- tery and allow it to run for several minutes before disconnecting the jumper cables. 10. Remove the jumper cables in oppo- site order of hook-up (4, 3, 2, 1). Be careful not to short cables against bare metal. ATV-0052 When installing the spark plug, be sure to tighten it securely. A new spark plug should be tightened 1/2 turn once the washer con- tacts the cylinder head. A used spark plug should be tightened 1/8 - 1/4 turn once the washer contacts the cylinder head. NOTE: Have the battery and elec- trical system checked prior to operating the vehicle again.

Throttle Cable Adjustment Spark Plug(s) This ATV comes equipped with a specified spark plug. See the specifications chart for the correct spark plug. A light brown insu- lator indicates that the plug is correct. A white or dark insulator indicates that the engine may need to be serviced. Consult an authorized Arctic Cat ATV dealer if the plug insulator is not a light brown color. To help prevent cold weather fouling, make sure to thoroughly warm up the engine before operating. To adjust the throttle cable free-play: 1. Loosen the jam nut from the throttle cable adjuster. 2.

Slide the rubber boot away and turn the adjuster until the throttle lever has proper free-play of 3-6 mm (1/8- 1/4 in.). To maintain a hot, strong spark, keep the plug free of carbon. Before removing the spark plug, be sure to clean the area around the spark plug. If you do not, dirt could enter engine when removing or installing the spark plug. CF297A 70