1000 GZ019 5. Fill a wash pan larger than the ele- ment with a non-flammable cleaning solvent; then dip the element in the solvent and wash it. FI704A Draining V-Belt Cover NOTE: If the ATV has been driven through water, the V-belt cover must be drained of any water. NOTE: Foam Air Filter Cleaner and Foam Air Filter Oil are avail- able from Arctic Cat. 1. Place the ATV on a level surface. 6. Squeeze the element by pressing it between the palms of both hands to remove excess solvent. Do not twist or wring the element or it will develop cracks. 2. Remove the drain bolt from the cover and allow the water to drain out. 7. Dry the element. 8.
Put the element in a plastic bag; then pour in air filter oil and work the oil into the element. 9. Squeeze the element to remove excess oil; then install in the frame. CF110A 3. Shift the range lever to the neutral position; then start the engine. CAUTION A torn air filter can cause damage to the engine. Dirt and dust may get inside the engine if the element is torn. Carefully examine the element for tears before and after cleaning it. Replace the ele- ment with a new one if it is torn. 4. Increase and decrease engine RPM several times to “blow out” any water; then stop the engine. 5. Install the drain bolt and tighten securely. 10.
Clean any dirt or debris from inside the air filter housing. NOTE: The V-belt and clutches should be inspected every 500 miles and the belt replaced (if nec- essary). 11. Place the filter in the air filter hous- ing making sure it is properly in position and seated; then install the cover and secure with the fasteners. Tires Air Filter Housing Drains ! WARNING Always use the size and type of tires as specified. Refer to the specifica- tions chart for proper tire inflation pressure, and always maintain proper tire inflation pressure. Inspect the drain beneath the main hous- ing for debris and for proper sealing. 72